Ultra-Tec Push-Lock PL-4-3.030 Cable Railing Fitting for Metal Posts

$19.76

Ultra-Tec Push-Lock PL-4-3.030

  • Works With Cable Size: 1/8″
  • Swageless Fitting
  • Non-Tensioning Fitting

Stainless Steel Cable Not Included

Available on backorder

Print This Page SKU: 20CFPL43030 Categories: ,

Description

The Push-Lock® is a concealed, swageless, non-tensioning, through-the-post-mounted fitting that is suitable for use on level runs only, and is available for 1/8” and 3/16” diameter 1×19 stainless steel cable.

The Push-Lock® fitting must be used with a tensioning fitting on the opposite end of the run. This fitting is installed into a pre-drilled hole in the end post. Using the Push-Lock® fitting requires enough clearance on the back side of the end post (to install the fitting through the back side of the post) and that amount of clearance depends on the length of the Push-Lock® fitting chosen. This fitting is furnished with a Delrin® washer that is installed between the shoulder of the fitting and the end post to protect the surface of the finish of the end post as tension is applied. It is recommended that you choose a length of PushLock® that is the same as the cross section dimension of the end post. The cable attaches to the fitting via our Push-Lock® locking wedge system which requires no special tools.

This fitting is made to look similar to the Invisiware® Receiver from the exterior of the post, so it is recommended to use a Receiver with stud on the opposite end whenever practical to maintain a consistent look.

Additional information

Weight 0.1 lbs
Dimensions 1 × 1 × 1 in
For Cable Size(s)

1/8" Cable

Tensioning or Not

Non-Tensioning

Swaged or Not Swaged

Swageless

Brand

Product CAD file

Drawing file for this part is not currently available.

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.